Avitech Rainier-4d Manual de usuario descargar pdf (Pagina 45)

1.7 Using the Phoenix-Q Configuration Software

The Phoenix-Q configuration software is designed for all Avitech multiviewers.

This program requires no installation and should not be run from a “read-only”

device, such as an optical disc. This section introduces the Phoenix-Q software

for setting up your system.

NOTE: Make sure the Rainier 3G is powered on and connected properly to your computer

before launching the Phoenix-Q software.

Connection Methods

There are two ways your Rainier 3G can connect to the controlling computer:

 Use the Ethernet cable (IP address) to connect (refer to the next section

“Setting Up Static IP”).

 Use the serial cable to connect (refer to a later section “Setting Up COM

Port”).

Setting Up Static IP

Before connecting the computers / controllers network to the Rainier 3G

computers with DHCP LAN connection will need to be changed to static IP,

similar range as the Rainier 3G (e.g., “192.168.0.5” – factory-default setting).

Or, change the IP address of the Rainier 3G Master unit to a similar range as the

controlling computer.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 186 187

Sin comentarios

Avitech Rainier-4d Manual de usuario Pagina 45